hemisphere gps trimble survey controller

Select/tap Green check mark to save settings and continue. Radio Mode: PC1 (FEC On) This is the default radio setting = GMSK Modulation, 9600 Baud Rate. Power: 1 Watt Frequency: manually enter the desired numerical UHF radio frequency. Configure Internal Microhard nl400 The user can observe the currently installed Microhard radio firmware version. GPS Base > RTK menu Configure RTK Device Retrieving settings, 25. GPS Base > RTK menu Configure RTK Device Selecting Modem/Radio S320 + GeoSurveyor Mobile Known RTK Base PT of 30 PN Rev. GPS Base > RTK menu Configure base Configuring base, 23. GPS Base > RTK menu Configure RTK Device Sending Data, 22. Select GPS Base > RTK menu, Device: Internal nl400 Microhard Select/tap Device: > Tools menu icon, 21. Advanced menu, Select Use GLONASS Select/tap Green check mark to continue, S320 + GeoSurveyor Mobile Known RTK Base PT of 30 PN Rev. If using Tripod + Tribrach > select Slant If using a Fixed Height GPS Tripod > Select Vertical. Select GPS Base > Receiver menu, Select the Antenna model: Measure and enter the RTK Base Antenna Height. Bluetooth Devices Select Base BT Device Bonding with Bluetooth 17. Select/tap the Bluetooth connection icon, 16. Bluetooth Device Select Base BT Device, Select the serial number of your S320 RTK Base GNSS receiver, 15. GPS Base > Current menu, Manufacturer: Hemisphere GNSS Model: S Select GPS Base > Comms menu, Type: Bluetooth BT Type: Windows Mobile Device: S xxxx Select/tap the BT Type > Tools menu icon, S320 + GeoSurveyor Mobile Known RTK Base PT of 30 PN Rev.

Job Settings > System menu, Select/Set Linear working Units for the current job, Select/Set the Angle, Lat/Long format, Select/Set the Zero Azimuth Setting, Edit Projection List > Local Coordinate System, Select/tap Green check mark to continue, 11. File > 1 Job menu, Loading job, S320 + GeoSurveyor Mobile Known RTK Base PT of 30 PN Rev. Select last used job, or create a new job, 9. Select/tap the SurvCE icon, S320 + GeoSurveyor Mobile Known RTK Base PT of 30 PN Rev. Select/tap the Windows start icon from the lower left corner of the Task Bar, 3. Windows Mobile 6.5 Professional Desktop, 2. These procedures are also valid for the Hemisphere XF1 data collectors and other Windows Mobile 6.5 Professional data collectors. Then using a known Coordinate Projection/System on the S320 RTK Rover equipment to collect RTK topographic points and/or perform RTK Stakeout surveys. Part Number Revised: MaOverview This document describes how to use the S320 GNSS Receiver and the GeoSurveyor Mobile software, (SurvCE) on the XF2 data collector to configure the S320 RTK Base over a known location/control point using the Equip > 2 GPS Base > From New Position > Enter Latitude/Longitude method. 1 S320 GNSS Receiver and GeoSurveyor Mobile Setup RTK Base on Known Control Point.

Hemisphere gps trimble survey controller